Filter
Top Products
DFX-6500
1.2.12 Paper and Media
1.2.12.1
Continuous paper (Single sheet and multi-part)
:opies
rotal Thickness
1 iinch)
luality
dulti-pati binding
‘erforation
lotes
I
Table 1-5. Continuous Paper
Front Entry
Rear Entry
Minimum
Maximum
Minimum Maximum
4.0
16.0 4.0
16.0
101
406 101
406
4.0
17.0 4.0
17.0
101
431 101
431
1 oriqinal
+ 6 copies 1 0ri~iw.l
+ 5 copies
0.0025
0.021 0.0025
0.018
0.065
0.53 0.065
0.46
52.6
62.7 52.6
62.7
14
22 14
22
41.4
56.4 41.4
56.4
11
15 11
15
Plain paper, Reclaimed paper, Carbonless multi-part forms
Rough bindings of multi-part paper cause paper jam.
.
.
.
.
.
.
.
.
.
.
The each sheet of multi-part paper should normally be put together by
spot-gluing, paper-stapling, tape stiiching. Spot-gluing is recommended
for the batter printing quality.
Spot-gluing must be applied on both sides of paper (Refer to Figure l-
7.).
The spot-glued parts must be pressed flat. There must be no creases in
the paper.
The paper-stapling must be applied from the front of paper and the
oaoer must be flat (Refer to Fiaure l-6.).
baier-stapling m&t be applied for both feeding directions (Refer to
Figure l-9.).
The paper-stapling should be flat (Refer to Figure l-10.).
Never use metal staples.
The position of binding must be outside of printable area.
Multi-part paper should be bound firmly to each other and the binding
must not be too large.
Refer to Section 1.2.12.5.
Refer to Section 1.2.12.6.
Figure 1-I. Dotted Paste Positions
7-12
Rev. A