Filter
Top Products
ADJUSTMENT
4.1.3 Tractor Wire Spring Tension Adjustment
This section describes the tractor wire spring tension adjustment. If the spring is not adjusted properly, paper
jams may occur, because the continuous paper tension (in the horizontal direction) is incorrect. When you
remove the front or rear tractor assembly, perform this adjustment.
Step 1: Remove the printer mechanism. (Refer to Section 3.2.6)
Step 2: Release the release levers for the tractor sprockets on the front.
Step 3: At the left side frame, loosen the CES(M4 X 6) screws securing the tire holding plate (L).
Step 4: Pull the tractor wire left to make correct tension to the tractor wire. tire holding plate @ and the tip of
the gold seal are 5 mm (0.2 inches) apart.
Step 5: Fix the CBS(M4 X 6) screws on the wire holding plate (L).
Step 6: As the same manner, adjust the tractor spring tension for the rear tractor.
Wke Holding Plate (L)
Figure 4-3. Tractor Wire Tension Adjustment (Front)
Rev. A
4-3