Filter
Top Products
9-11
Alarms
Alarm Actions
9
E-mail settings for Surveyor hosts and THGs hosts are slightly different. For
analyzer devices in Surveyor hosts, you set the list e-mail recipients for alarms from
the
Host → Alarm Setting → E-mail Settings... menu. All other e-mail configuration
is performed from the local e-mail utility. For THGs, e-mail is completely
configured from the
Host → Alarm Setting → E-mail Settings... menu. You set the
sender address, SMTP domain, and the SMTP mail server address as well as the list
of e-mail recipients for alarms. An example dialog box for setting up e-mail for
THGs hosts is shown below.
Figure 9-4. E-Mail Settings for THGs
Pager Settings
The host must have a modem to use a pager. You must set an appropriate delay time
when making a call to a pager.
When making a call to a pager, a single number can be configured from the
Host →
Alarm Setting → Pager Settings... menu. Setting the pager number for alarm actions
is a global setting for the host. All alarms reported for analyzer devices in the host
will go to the same pager number. public
SNMP Trap Settings
SNMP traps containing alarms can be sent to specified management stations as one
of the alarm actions. Each host has its own list of management stations to receive
traps. A set of management stations identified by their IP addresses is called a
community.
Any alarm, when triggered, is sent to all IP addresses specified in all communities
configured for the host.