HP (Hewlett-Packard) 2840 Printer User Manual


 
Changing the default resolution setting
Resolution, in dots per inch (dpi), affects the quality of faxed documents. It also affects the
transmission speed as a higher resolution produces a larger file, which requires more time to
transmit. The factory-set default resolution setting is Fine.
Use this procedure to change the default resolution for all fax jobs to one of the following
settings:
Standard: This setting provides the lowest quality and the fastest transmission time.
Fine: This setting provides a higher resolution quality than Standard that is usually
appropriate for text documents.
Superfine: This setting is best used for documents that mix text and images. The
transmission time is slower than Fine but faster than Photo.
Photo: This setting produces the best images, but greatly increases the transmission
time.
To change the default resolution setting
1. On the device control panel, press M
ENU
.
2. Use the < or the > button to select Fax setup, and then press E
NTER
.
3. Use the < or the > button to select Fax Send setup, and then press E
NTER
.
4. Use the < or the > button to select Def. Resolution, and then press E
NTER
.
5. Use the < or the > button to change the resolution setting.
6. Press E
NTER
to save the selection.
Note
For instructions about changing the resolution for the current fax job only, see To adjust the
resolution for the current fax job.
88 Chapter 8 Fax ENWW