HP (Hewlett-Packard) 2840 Printer User Manual


 
To change the alarm volume
The alarm sounds when the device is presenting an alert or critical error message. The
alarm duration length is either one or three seconds, depending on the type of error.
1. Press M
ENU
.
2. Use the < or the > button to select System setup, and then press E
NTER
.
3. Use the < or the > button to select Volume settings, and then press E
NTER
.
4. Press E
NTER
to select Alarm volume.
5. Use the < or the > button to select Off, Soft, Medium, or Loud.
6. Press E
NTER
to save your selection.
Note
The factory-set default for the alarm volume is Soft.
To change the volume for the fax
This setting determines the volume of various fax sounds that occur when the device is
sending or receiving fax jobs.
1. Press V
OLUME
.
2. Use the < or the > button to select Off, Soft, Medium, or Loud.
3. Press E
NTER
to save your selection.
Note
The factory-set default is Soft.
To change the ring volume of the fax
The fax ring sounds when the device is initially sending or receiving a call. The ring duration
length depends on the local telecom ring-pattern length.
1. Press M
ENU
.
2. Use the < or the > button to select System setup, and then press E
NTER
.
3. Use the < or the > button to select Volume settings, and then press E
NTER
.
4. Press the < or the > button once to select Ring volume, and then press E
NTER
.
5. Use the < or the > button to select Off, Soft, Medium, or Loud.
6. Press E
NTER
to save your selection.
Note
The factory-set default is Soft.
34 Chapter 4 Using the device ENWW