Filter
Top Products
Control panel message Description Recommended action
The supplies gauge will display the
consumption levels of print cartridges.
3. Remove the incorrect print cartridge.
4. Install the correct print cartridge.
5. Close image transfer unit and then close
the top and front covers.
Calibrating... The printer is calibrating. No action necessary.
Canceling... X The printer is in the process of canceling a
job. The message will continue to be
displayed while the job is stopped, the paper
path flushed, and any remaining incoming
data on the active data channel is received
and discarded.
No action necessary.
CARD SLOT X
NOT FUNCTIONAL
The flash card in slot X is not working
correctly.
1. Turn the printer off.
2. Remove the card from the slot indicated
and replace with a new card.
Checking paper path The engine is turning its rollers to check for
possible paper jams.
No action necessary.
Checking printer The engine is doing an internal test. No action necessary.
CHOSEN PERSONALITY
NOT AVAILABLE
alternates with
CHOSEN PERSONALITY
NOT AVAILABLE
For help press
PJL encountered a request for a personality
that did not exist in the printer. The job is
aborted and no pages will be printed.
1.
Press
for detailed information.
2. Press
and to step through the
instructions.
3. Reprint using the correct driver for the
device.
CLEANING DISK X% COMPLETE A storage device is being cleaned. Do not
turn the printer off. When the process is
complete, the printer will automatically
restart.
No action necessary.
Cleaning... A cleaning page is being processed. No action necessary.
Clearing event log This message is displayed while the event log
is cleared. The printer will exit the MENUS
once the event log has been cleared.
No action necessary.
Clearing paper path The printer jammed or detected misplaced
paper when turned on. The printer is
attempting to eject jammed pages
automatically.
No action necessary.
CLOSE FRONT COVERS
For help press
The top cover needs to be closed. Close front covers.
NOTE This message might also
appear if the fuser is missing or
incorrectly installed. Ensure that the
fuser is correctly installed.
Close top cover. The top cover of the printer is open. Close the top cover.
ENWW Control panel messages 167