Filter
Top Products
Network configuration
You might need to configure certain network parameters on the printer. You can configure these
parameters from installation software, the printer control panel, the embedded Web server, or
management software, such as HP Web Jetadmin.
NOTE For more information about using the embedded Web server, see Using the embedded
Web server.
For more information about supported networks and network configuration tools, see the HP Jetdirect
Print Server Administrator’s Guide. The guide comes with printers in which an HP Jetdirect print server
is installed.
This section contains the instructions for configuring TCP/IP network parameters from the printer control
panel:
Configuring TCP/IP parameters
You can use the printer control panel to configure these TCP/IP parameters:
●
IP address (4 bytes)
●
Subnet mask (4 bytes)
●
Default gateway (4 bytes)
Manually configuring TCP/IP parameters from the printer control panel
Use manual configuration to set an IP address, subnet mask, and default gateway.
Setting an IP address
1. Press Menu to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EMBEDDED JETDIRECT MENU.
7. Press
to select EMBEDDED JETDIRECT MENU.
8. Press
to highlight TCP/IP.
9. Press
, highlight IPV4 SETTINGS, and then press to select IPV4 SETTINGS.
10. Press
and select CONFIG METHOD.
11. Press
to highlight MANUAL, and then press .
12. Press
to highlight MANUAL SETTINGS.
13. Press
to select MANUAL SETTINGS.
70 Chapter 3 I/O configuration ENWW