Filter
Top Products
RAM disk
This option allows you to specify how the RAM disk is configured. Options are AUTO and OFF. When
set to AUTO, the printer determines the optimal RAM size based on the amount of available memory.
The message displays only in printer models that do not have a hard disk installed. The default is
AUTO.
Changing RAM disk behavior
You can change this behavior at any time by following these steps:
1. Press Menu to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight SYSTEM SETUP.
5. Press
to select SYSTEM SETUP.
6. Press
to highlight RAM DISK.
7. Press
to select RAM DISK.
8. Press
or to select AUTO or OFF.
9. Press
to set the selection.
10. Press Menu.
Language
On some products, the option to set the default language appears when the printer is first initialized.
Use the
or arrow to scroll through the available options. When the desired language is highlighted,
press the
to set the default language. The default language is ENGLISH.
You may also change the language at any time by following these steps:
Selecting the language
1. Press Menu to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight SYSTEM SETUP.
5. Press
to select SYSTEM SETUP.
6. Press
to highlight LANGUAGE.
7. Press
to select LANGUAGE.
8. Press
or to select the appropriate language.
9. Press
to set the selection.
10. Press Menu.
ENWW Changing printer control panel configuration settings 65