Filter
Top Products
5 - 48
Password
Start > Settings > Control Panel > Password
Use this panel to set MX9 user access to control panels and power up password properties.
Important: This password must be entered before performing a Load Factory Defaults on the Registry control panel.
Contact Technical Assistance (page 15-1) if entering a power-on or screen saver password does not allow you to disable
this password protection or perform a Load Factory Defaults.
Enter the password in the Password text box, then press Tab and type the password again to confirm it.
Enable the power-on check box and, if desired, the screensaver check box. A changed/saved password is in effect immedi-
ately.
• The password and password settings are saved during a warm boot and a cold boot.
• The screensaver password affects the Remote Desktop screensaver only.
• After a password is assigned and saved, each time a Settings > Control Panel option is selected, the user will be
required to enter the password before the Control Panel will open.
• The screensaver password is the same as the power-on password. They are not set independently.
• A screensaver password cannot be created without first enabling the “Enable password protection at power-on” check
box.
• The screensaver password is not automatically enabled when the “power-on” check box is enabled.
Setting Default
Password Blank
Enter password at Power On Disabled
Enter password at Remote Desktop Screen
Saver
Disabled