Filter
Top Products
10 - 9
It is important the Radio Mode parameter correspond to the Access Point (AP) to which the device is to connect. For
example, if this parameter is set to G rates only, the MX9 may only connect to APs set for G rates and not those set for
B and G rates.
The options for the Radio Mode parameter should be set, based on the antenna configuration, as follows:
Contact Technical Assistance (page 15-1) if you have questions about the antenna(s) installed on your MX9.
Radio Mode BG radio:
BG Rates Full
Or
A radio:
BGA Rates Full
Specify 802.11a, 802.11b and/or 802.11g rates when communicating
with the AP. The options displayed for this parameter depend on the type
of radio installed in the mobile device.
Options:
• B rates only (1, 2, 5.5 and 11 Mbps)
• BG Rates Full (All B and G rates)
• G rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps)
• BG optimized or BG subset (1, 2, 5.5, 6, 11, 24, 36 and 54 Mbps)
• A rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps)
• ABG Rates Full (All A rates and all B and G rates with A rates
preferred)
• BGA Rates Full (All B and G rates and all A rates with B and G rates
preferred)
• Ad Hoc (when connecting to another client device instead of an AP
Default:
• BG Rates Full (for 802.11b/g radios)
• BGA Rates Full (for 802.11a/b/g radio)
Note: BG radio only - Previous SCU versions may have the default set
as BG Rates Full. Depending on the SCU version, either BG
Optimized or BG subset is the default.
Antenna Configuration Radio Mode
A Main and BG Main ABG Rates Full
BGA Rates Full
A Main and A Aux A Rates Only
BG Main and BG Aux B Rates Only
G Rates Only
BG Rates Full
BG Subset
Parameter Default Explanation