Filter
Top Products
1 - 1
1
MX9 Agency Compliance
MX9 mobile computers meet or exceed the requirements of all applicable standards organizations for safe operation. However,
as with any electrical equipment, the best way to ensure safe operation is to operate them according to the agency guidelines
that follow. Read these guidelines carefully before using your MX9.
This documentation is relevant for the following models: MX9, MX9CS, MX9HL.
Laser Warnings
• Do not look into the laser’s lens.
• Do not stare directly into the laser beam.
• Do not remove the laser caution labels from the MX9.
• Do not connect the laser bar code aperture to any other device. The laser bar code aperture is certified for use with the MX9
only.
Laser Label Location
Laser Safety Statement
This device has been tested in accordance with and complies with IEC60825-1 ed2 (2007). Complies with 21 CFR 1040.10 and
1040.11, except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007.
LASER LIGHT, DO NOT STARE INTO BEAM, CLASS 2 LASER PRODUCT, 1.0 mW MAX OUTPUT: 630-680nM.
Model Number, Serial Number and IMEI Labels
The model (item) number, serial number, and international mobile equipment identity (IMEI) number for the terminal are located
on labels affixed to the back of the terminal.
FCC Part 15 Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
Caution:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. The battery should be
disposed of by a qualified recycler or hazardous materials handler. Do not incinerate the battery or dispose
of the battery with general waste materials.
Caution:
Laser radiation when open. Read the caution labels. Use of controls, adjustments or performance of
procedures other than those specified herein may result in hazardous radiation exposure.
f the following label is attached to your MX9, it indicates the MX9 contains an
engine with a laser aimer:
!
!