Filter
Top Products
13 - 25
Removing the MX9 from the Mounted Vehicle Cradle
1. Place one hand on the MX9 and press one of the release latches (located on either side of the cradle docking bay).
2. The MX9 disconnects from the cradle pins and springs forward.
3. Grasp the MX9 and pull it up and out of the vehicle cradle, disconnecting the MX9 I/O port from the charge/
communication port at the base of the docking bay.
Powered Vehicle Cradle Help
The following is intended as an aid in determining whether the MX9 or the vehicle mounted cradle may be malfunctioning.
Issue Cause Solution
MX9 docked in cradle
but cannot work with
accessory cables
connected to cradle.
MX9 I/O port not fully connected to
communication/charging port in
docking bay.
There are foreign objects inside
docking bay or cable connectors
Reseat the MX9 fully into the docking bay.
Remove the foreign objects and reseat the MX9 in
the docking bay.
MX9 docked in cradle
but Docked LED does
not light up.
MX9 not fully docked.
Power supply not connected.
Check the docking bay is clear of foreign objects
and reseat the MX9 fully into the docking bay.
Check that power cable is securely connected to
the Power Port at the rear of the cradle.