Filter
Top Products
10 - 33
WPA PSK
To connect using WPA/PSK, make sure the following profile options are used:
1. Enter the SSID of the Access Point assigned to this profile.
2. Set EAP Type to None.
3. Set Encryption to WPA PSK or WPA2 PSK.
4. Set Auth Type to Open.
5. Tap the WEP keys/PSKs button.
6. This value can be 64 hex characters or an 8 to 63 byte ASCII value. Enter the key and tap OK.
7. Once configured, tap the Commit button.
8. Ensure the correct Active Profile is selected on the Main tab and Warmboot. The SCU Main tab shows the device is
associated after the radio connects to the network.