Filter
Top Products
7 - 15
Using OPP
Pairing with an OPP Device
Prerequisites
• A remote device, such as a mobile phone, that supports OPP.
• OPP is enabled on the MX9.
1. Place the remote device in discovery or visible mode.
2. Initiate discovery on the MX9 by tapping the Discover button on the OPP Send tab.
3. The MX9 discovers the remote device.
4. The MX9 attempts to send a file to the remote device.
5. The remote device prompts the user for a 4 digit PIN.
6. User enters the PIN.
7. The MX9 prompts the user for a 4 digit PIN.
8. User must enter the same PIN code as entered on the remote device.
9. The MX9 now pairs with the remote device.
Remote Device Pushes File to MX9
This section assumes that a device supporting OPP is paired with the MX9.
If a duplicate filename is received, EZPair (or LXEZ Pairing) writes the file in the specified location, with an incremental
number appended to the file name. For example, if a file named file.jpg is pushed to the MX9 and that filename already
exists in the Inbox, EZPair saves the new file as file001.jpg. If the same file is pushed again, it is saved as file002.jpg.
Following are several scenarios based on configuration options on the OPP Setup tab.
Notifications enabled, MX9 is Write Capable
1. The OPP client initiates a connection to the MX9 by selecting a file to push to the MX9.
2. The MX9 user is notified that a File Push request has been issued from a remote device.
3. The MX9 user is prompted to accept or reject the incoming request.
4. If the user accepts the request:
• The file is pushed to the MX9.
• EZPair notifies the user that a file has been received.
• The connection is closed by the remote device (OPP client).
5. If the user rejects the request:
• The file is not pushed to the MX9.
• The connection is closed.
Notifications enabled, MX9 is not Write Capable
1. The OPP client initiates a connection to the MX9 by selecting a file to push to the MX9.
2. The file is rejected silently (no notification to the MX9 user).
Notifications disabled, MX9 is Write Capable
1. The OPP client initiates a connection to the MX9 by selecting a file to push to the MX9.
2. The file is accepted silently (no notification to the MX9 user).
Notifications disabled, MX9 is not Write Capable
1. The OPP client initiates a connection to the MX9 by selecting a file to push to the MX9.
2. The file is rejected silently (no notification to the MX9 user).