Filter
Top Products
13 - 9
A fully depleted spare battery recharges in approximately four hours in the MX9 powered cradle. Charging time may take
longer if a tethered scanner, connected to the Serial port and drawing power from the cradle, is used.
The spare battery charger can recover a battery that has had its safety circuit tripped.
The spare battery well is molded in the shape of the MX9 main battery. The spare battery can be inserted in the battery well
in only one direction. When there is an MX9, with or without a handle, docked in the cradle, a spare battery can still be
inserted in the charging bay. You do not need to undock the MX9 before inserting or removing a Spare battery.
Stabilize the cradle with one hand when inserting/removing the spare battery, if necessary.
Inserting a Spare Battery
1. Hold the battery with the charging terminals facing down, toward the charging pocket.
2. Tilt the end (with the charging terminals) into the re-charging terminals at the front end of the spare battery charging
bay. Slide the battery forward until it is fully inserted into the battery bay.
3. Push down on the spare battery until the catch clicks into place, securing the spare battery in the battery bay. This
will ensure the charging contacts on the spare battery connect with the re-charging contacts in the battery bay.
4. The Spare charging bay LED illuminates indicating the battery is properly seated in the charging bay.
Removing a Spare Battery
A green Spare battery LED signifies the spare battery is charged.
Remove the Spare battery by sliding the latch in and pulling the Spare battery up, with a hinging motion, and out of the
charging bay. The Spare charging bay LED turns Off.
Desktop Cradle Help
The following is intended as an aid in determining whether the MX9 battery pack or the cradle battery charger may be mal-
functioning.
Issue Cause Solution
Battery pack does not
fit in battery well.
Different manufacturer's battery pack,
or there is an object in the battery
well.
Check if the battery pack is part number 161888-
0001 or a low temperature battery 161915-0001. If
not, do not use.
Remove the object from the battery well.
No battery pack in
spare battery charging
well, but the charging
LED is on.
Dirt or foreign objects are in the
battery well.
Unplug cradle from outlet. Remove any dirt or
foreign objects from battery well.
If the LED continues to stay ON, the cradle may be
defective. Return charger to an authorized
Honeywell service center.