Filter
Top Products
10 - 28
WPA/LEAP
To use WPA/LEAP, make sure the following profile options are used.
1. Enter the SSID of the Access Point assigned to this profile.
2. Set EAP Type to LEAP.
3. Set Encryption to WPA TKIP.
4. Set Auth Type as follows:
• If the Cisco/CCX certified AP is configured for open authentication, set the Auth Type radio parameter to Open.
• If the AP is configured to used shared key or passphrase, set the Auth Type radio parameter to Shared.
• If the AP is configured for network EAP only, set the Auth Type radio parameter to LEAP.
5. To use another encryption type, select WPA CCKM, WPA2 AES or WPA2 CCKM for encryption and complete other
entries as detailed in this section.
6. See Sign-On vs. Stored Credentials (page 10-17) for information on entering credentials.
7. To use Stored Credentials, tap on the Credentials button. No entries are necessary for Sign-On Credentials as the user
will be prompted for the User name and Password when connecting to the network.
8. Enter the Domain\User name (if the Domain is required), otherwise enter the User name.
9. Enter the password.
10. Tap OK then tap the Commit button.
11. Ensure the correct Active Profile is selected on the Main Tab and Warmboot. The SCU Main tab shows the device is
associated after the radio connects to the network.