Filter
Top Products
13 - 8
Spare Battery LED
Note: Spare battery charging does not require an MX9 be docked in the docking bay.
MX9 System Status LED Status when Docked
The MX9 System Status LED is located at the top of the keypad.
Docking and Undocking the MX9
When the MX9 is in Suspend Mode it wakes up when it is docked in a powered cradle. There is no change in mode state
settings or behavior when the MX9 is docked in a cradle without a power source.
MX9 mode states while the MX9 is in a powered cradle e.g., suspend, resume, display backlight, etc., are managed by the
MX9 OS Power settings.
If the cradle is not permanently attached to the work surface, stabilize the cradle with one hand while inserting or removing
the MX9 with the other hand.
The MX9 is inserted into the charging pocket with the keypad facing forward.
Dock the MX9
Remove any cables attached to the I/O port in the base of the MX9.
Carefully press the MX9 straight down into the docking bay until the multi-pin connector at the base of the MX9 clicks
into place with the multi-pin charging/communication connector at the bottom of the docking bay. The MX9 cradle is
designed to secure the MX9 facing front.
The cradle’s Docked LED illuminates.
Undock the MX9
Remove the MX9 from the cradle by pulling it straight up and out of the docking bay. If necessary, brace the cradle with
one hand while the other hand removes the MX9.
The cradle's Docked LED turns Off.
Inserting / Removing a Spare Battery from the Desktop Cradle
Prerequisites: The steps outlined in Assemble/Attach the AC Power Adapter (page 13-6) have been completed and the cra-
dle has a dependable power source. The cradle has been bolted to a stable surface, if desired.
Note: Do not drop or slam the spare battery into the charging pocket. Damage may result.
When Spare LED is … It means ….
Off Battery pack not inserted or no power applied
Green Battery pack fully charged
Red Battery pack charging
Yellow / Amber Battery pack temperature out of range
Flashing Red Battery pack fault or failure
When the LED is . . . The Status is . . . Comment
Blinking Red Power Fail Replace the main battery with a fully charged main
battery.
Or
Connect the MX9 to external AC power to allow the
internal charger to charge the main battery e.g., dock in a
powered cradle.
Steady Red Main Battery Low Low Battery Warning. Replace the main battery with a fully
charged main battery. Or dock the MX9 in a powered
cradle.
Blinking Green Display Off No user intervention required.
No Color Good No user intervention required.