Filter
Top Products
2 - 19
Attaching the Hand Strap
Note: Either the trigger handle is attached to the MX9 or the hand strap is attached, not both. In the absence of a trigger handle,
the hand strap should be used at all times. The hand strap is pre-installed on a MX9 that is purchased without a trigger
handle.
1. Place the MX9 with the screen facing down, on a flat stable surface.
2. Place the hand strap base (2) in the grooved area, matching the screw holes in the hand strap base with the screw holes in
the body of the MX9.
3. Insert the screws (supplied) into each of the four holes and fasten the base securely.
4. Slide the hand strap bottom clip pins into the slots at the base of the MX9 and pull the strap towards the top of the MX9 until
the top clip slips into the groove.
5. Making sure the closed loop fastener surface on the hand strap are facing up, slide the strap through the latch in the top clip.
6. Fold the end of the strap over so that the closed loop fastener surfaces mate evenly and the hand strap is secured to the
MX9.
7. Test the strap's connection making sure the MX9 is securely connected to each end of the strap connectors.
Check the closed loop fastener and hand strap base connection frequently. If loose, they must be tightened or replaced before
the MX9 is placed into service again.