Filter
Top Products
2 - 24
Replacing the CLA Fuse
Equipment needed: 5A fuse of the same size and amperage.
1. Remove the CLA from the cigarette lighter outlet on the vehicle.
2. Disconnect the cable from the MX9.
3. Unscrew the tip of the adapter end.
4. Replace the blown fuse with a fuse of the same rating and size.
5. Screw the tip back on to the adapter end, replacing any previously removed parts in the order in which they were removed.
Upon reassembling the cigarette lighter adapter with the new fuse, and plugging it into the cigarette lighter port on the vehicle --
if the LED on the CLA does not illuminate green, there may be a problem with your vehicle power source.
Cleaning the Touch Screen and Scanner Aperture
Note: These instructions are for components made of glass. If there is a removable protective film sheet on the display, remove
the film sheet before cleaning the screen.
Keep fingers and rough or sharp objects away from the bar code reader scanning aperture and the mobile device touch screen.
If the glass becomes soiled or smudged, clean only with a standard household cleaner such as Windex® without vinegar or use
Isopropyl Alcohol. Dampen the cloth with the cleaner and then wipe the surface.
Do not use paper towels or harsh-chemical-based cleaning fluids since they may result in damage to the glass surface. Use a
clean, damp, lint-free cloth.
Do not scrub optical surfaces. If possible, clean only those areas which are soiled. Lint and particulates can be removed with
clean, filtered canned air.