Filter
Top Products
106 Intel Storage System SSR212PP User Guide
Revision 1.0
PRELIMINARY
STEP 6. Using the information from the completed worksheet in the "Storage System Management
Ports" section of Procedure 1, "Planning Your Fibre Channel Storage System
Configuration," on page 1, follow the instructions on the screen to set the following
management user account settings for the storage system:
STEP 7. Review and apply the settings.
On a Windows host,
i. Click
Next to view the summary of the management user account settings for
storage system.
ii. In the message box about the storage system having been initialized, click
OK.
iii. If the settings are correct, click
Finish.
On a Linux host,
i. Apply the values by typing
a.
ii. Exit the utility by typing
e.
If you entered an SP IP address for the first time or changed an SP IP address, the utility
reboots the storage system and the SP Boot/Fault light on the back of each SP starts
blinking (Figure 51 on page 118 or Figure 52 on page 118). The reboot takes several
minutes to complete. When it is completed, the SP Boot/Fault light on each SP stops
blinking and remains off.
Changing the Management Network and Account Settings
STEP 1. Shut down the storage system. See Procedure 20, "Shutting the Storage System Down,"
on page 111.
STEP 2. Reset the storage system: At least one minute after the storage system shuts down, press
the power button, hold it down for at least four seconds, and then release it. When the
start-up is complete, the storage system is uninitialized. You must rerun the Navisphere
Initialization Utility to reset the management network parameters and the user account
settings.
STEP 3. Rerun the Navisphere Initialization Utility to set the parameters.
Account Setting Description
User name
Username for the management port. A valid
username must start with a letter, can contain only
letters and numbers, cannot exceed 32 characters, and
is case—sensitive. For example,
blindmice3 is a valid
username and is different from BLINDMICE3.
Password
Password for the user connected to the management
port. A valid password can contain only letters and
numbers, cannot exceed 32 characters, and is case—
sensitive. For example, mousetrap2 is a valid
password and is a different password from
MOUSETRAP2.
Confirm Password
Previously entered password for password
verification.