Intel SSR212PP Network Card User Manual


 
146 Intel Storage System SSR212PP User Guide
Revision 1.0
PRELIMINARY
# IncomingPassword=foo
# TargetName Specific Settings
# ----------------------------
# Target-specific settings should be entered
respective "TargetName"
# entries. If Multipath is enabled, then
target-specific settings will be
# be applicable for all iSCSI sessions
#
# If settings under "Subnet" entry are
settings under
# "TargetName" entry, the settings under
be considered.
#
#TargetName=iqn.1987-05.com.cisco:00.0d1d898e8d66.
#
# The TargetName Settings can have the
specific to a target.
#
# 1) CRC Settings # 2) iSCSI Operational
settings
# 3) Connection Timeout Settings
# 4) Session Timeout Settings
# 5) Error Handling Timeout Settings
# 6) TCP Settings
# 7) Portal Failover Settings
# 8) Multipath Settings
# 9) LUN settings
# 10) PreferredSubnet and PreferredPortal
# NOTES:
# ------
# If any of the configuration parameters
mentioned under Configuration
# type DiscoveryAddress, TargetName or
values will be
# considered if they are specified, else
settings will apply for these
# configuration parameters.
#
# All entries specified below any of the
types must be indented
# by a whitespace character or a tab to
local to a category. If
# they are specified in the 1st column
default considered as global
#
# Example: # #Subnet=127.0.0.1 # ActiveTimeout=10
# PingTimeout=10
# LoginTimeout=30
#
# In the above case LoginTimeout is considered a global
value and will have
# scope until another LoginTimeout entry is specified.
# If there are conflicting entries for the same target
through the Subnet and
# TargetName or DiscoveryAddress entries, the Subnet
entries in the file will
# take precedence.
#
# Example:
#
#Subnet=127.0.0.1 # ActiveTimeout=10
#
#TargetName=iqn.1987-05.com.cisco:00.0d1d898e8d66.t0