Intel SSR212PP Network Card User Manual


 
176 Intel Storage System SSR212PP User Guide
Revision 1.0
PRELIMINARY
FIGURE 67. Screen Shot: Select Images to Install
STEP 9. Select the recovery image to install. The correct filename has the form
FLARE-aa.bb.ccc.d.eee.mif.
CAUTION
If there is no filename with the form FLARE-aa.bb.ccc.d.eee.mif, then no
recovery image exists. You cannot continue with this procedure until you have
obtained a recovery image. See Procedure 33, "Using FTP to Obtain and Store an
SP Boot Image," on page 179.
After you have specified an image, the software displays the Conrm Image Installation
screen.
STEP 10. Enter y if the image selection is correct. The software then displays the Select Storage
Processors to Install screen.
STEP 11. Select This SP as the SP you want to recover because it is the SP you physically connected
with the serial cable.
For example, if you are restoring the image to SP B, select SP B only. Do not try to restore
images to both SPs in one procedure.
After you have selected an SP, the software copies the image to the boot drives of that SP.
It displays a screen that shows the percentage copied, similar to the one shown in
Figure 68. The copy may take up to 10 minutes.