Intel SSR212PP Network Card User Manual


 
Intel Storage System SSR212PP User Guide 179
33
PRELIMINARY
Using FTP to Obtain and
Store an SP Boot Image
This procedure explains how to load and use an SP boot recovery image using FTP (File
Transfer Protocol).
Use this procedure if there is no usable recovery image in the storage system. The
instructions assume that you have opened a HyperTerminal (or equivalent) session and
that you have completed
STEP 1 through STEP 5 in Procedure 32, "Restoring a Storage
Processor Boot Image," on page 169.
If you stopped the preceding recovery procedure at step 6, the software is displaying the
Select Images to Install screen without a file of the form FLARE-aa.bb.ccc.d.eee.mif
(compare Figure 69 to the screen shown in Figure 67 on page -176).
FIGURE 69. Screen Shot: Select Images to Install
STEP 1. Obtain a recovery file, or information on how to access a recovery file, from your
authorized service provider. The recovery filename has the form FLARE-
aa.bb.ccc.d.eee.mif.
STEP 2. On the Select Images to Install screen, press the Enter key without specifying a number.
The software displays the
Conrm Image Installation screen.