Filter
Top Products
Diagnostic Information 2-71
5016-001
C Paper jam 202 displays indicating media is detected and fed from
tray x and paper jams after it passes the paper pass sensor.
Parallel Port Service Check
Run the “Parallel Wrap Test” on page 3-11.
The Parallel Wrap Test is designed to check the parallel port
hardware by using a wrap plug (P/N 1319128) which invokes the
Parallel Diagnostic Test. This test helps isolate the printer from the
parallel cable and host. The test provides displays failure information
for approximately 3 seconds. If the test detects a problem, replace
the controller board.
FRU Action
1 Fuser Assembly
Paper Exit Sensor
Flag and Spring
Heat Insulating
Cover 1
Fuser assembly available:
Try a new fuser assembly before proceeding
with this service check.
Fuser assembly not available:
If the media jams over the exit sensor, check the
exit sensor flag and spring for correct operation
and loose or broken parts. If a problem is found,
replace as necessary.
Check the heat insulating cover 1 for anything
that would cause a paper jam.