Filter
Top Products
2-110 Service Manual
5016-001
A It is difficult to remove tray x from the 250/250 option base
assembly.
Note: Do not force tray x from the base unit, as damage to the
paper detect sensor lever, or pick up roller bracket assembly may
occur. Lift up on the bracket and sensor lever and carefully remove
tray x.
B You are unable to select the 250/250 tray option. The option is not
recognized.
FRU Action
1 Paper Detect
Sensor Lever
Release Lever
Pick Up Return
Spring
Feed Frame
Check the paper feed frame, paper detect sensor
lever, release lever and pick up spring, for the
failing tray, for correct installation and operation.
If incorrect, repair as necessary.
FRU Action
1 Option Cable
OP Autoconnect
Base Printer
Cable (OP)
Autoconnect
Be sure cable OP is correctly installed on the
interconnect board at CN801. Check both the
option and base OP printer cables for signs of
damage, especially to the autoconnect connector
pins. Replace either cable, if any problems are
found.
2 Interconnect
Board
Engine Board
Replace the following FRUs in the order shown:
1. Option interconnect board
2. Engine board