Filter
Top Products
1-18 Service Manual
5016-001
Contact Cam
Operation of transferring from the OPC to the transfer belt
The contact cam is stopped at the position shown in figure below.
The pins fit into the grooves of the cam. Lever 1 and lever 2 are
controlled at the position shown. The pin fits into the groove in lever
1 which controls the position of the transfer roller cam, detaching
transfer roller from the transfer belt. The discharge roller is also
detached from the transfer belt at this time. A pin in the side of lever
2 controls the cleaner lever which controls the position of the
cleaner. The cleaner is detached from the transfer belt.
Operation of transferring from the belt to the paper
The contact cam rotates according to the movement of the solenoid
and spring clutch and stops. The revolution of the cam is transmitted
in the following order: transfer roller, discharge roller and cleaner.