Filter
Top Products
2-8 Service Manual
5016-001
Waiting The printer has received a
page of data to print but is
waiting for an End of Job or
Form Feed command or for
additional data.
• To print the contents of
the print buffer, press
Go.
• To cancel the print job,
press
Menu> or <Menu
until the Job Menu is
displayed. Press
Select.
Press
Menu> or <Menu
until Cancel Job appears
on the second line.
Press
Select.
Not Ready The printer is not ready to
receive or process data,
because someone selected
Stop when another
message was displayed.
• Press
Go to remove the
printer from the Not
Ready state.
• To cancel the print job,
press
Menu> or <Menu
until the Job Menu is
displayed. Press
Select.
Press
Menu> or <Menu
until Cancel Job appears
on the second line.
Press
Select.
Ready Hex Hex Trace diagnostic mode
is active, and the printer is
ready to receive data.
Use Hex Trace to isolate
the source of a print job
problem. With Hex Trace
selected, all data sent to
the printer is printed in
hexadecimal and character
representation.
Control code strings are
printed, not executed.
• To exit Hex Trace mode,
turn the printer off or
reset the printer.
• To reset the printer,
press
Menu> or <Menu.
When the Job Menu is
displayed press
Select.
Press
Menu> or <Menu
until Reset Printer
appears on the second
line. Press
Select.
Locking Menus Someone has locked the
menus. While the menus
are locked, users cannot
change the printer default
settings from the operator
panel.
N/A
Message Status Action