Filter
Top Products
4-22 Service Manual
5016-001
Resist Sensor Board Removal
1. Remove all covers, refer to the “Cover Removals” on
page 4-2.
2. Remove the LVPS assembly, refer to the “LVPS Assembly
Removal” on page 4-10.
3. Remove the C-clip and the shaft bearing from the left side of the
registration roll.
4. Unlatch the cable cover bracket.
5. Loosen the registration roll from the left side.
6. Remove the two (2) screws from the paper A guide and remove
the guide.
7. Remove the two (2) screws from the paper sensor and remove
the sensor.
Waste Toner Board Assembly Removal
1. Remove the grid 1 block assembly, refer to the “Grid Block 1
Assembly Removal” on page 4-16.
2. Remove the two (2) screws from the board.
3. Remove the waste toner board assembly.