Filter
Top Products
Diagnostic Information 2-17
5016-001
35 Res Save Off
Deficient Memory
The printer lacks the
memory needed to enable
the Resource Save
function. This message
usually indicates that too
much memory is allocated
for one or more of the
printer link buffers.
To disable Resource Save
and continue printing, press
Go.
To enable Resource Save
after you get this message,
perform one of the following:
• Set the link buffer for
each interface to Auto.
Then exit the menus to
activate the link buffer
changes. When the
Ready message is
displayed, enable
Resource Save from the
Setup Menu.
• Install additional printer
memory.
37 Insufficient
Collation Area
The printer memory (or
optional hard disk, if
installed) does not have
the space necessary to
collate the print job.
Press
Go to print the portion
of the job already stored and
begin collating the rest of
the job.
To cancel the print job:
• Press
Menu> or <Menu
until the Job Menu is
displayed.
• Press
Menu> or <Menu
until Cancel Job appears
on the second line.
• Press
Select.
37 Insufficient
Defrag Memory
The printer is unable to
perform the requested
Flash Memory
Defragment operation
because the printer does
not have enough memory.
This message is posted
before the operation
begins to ensure items in
flash memory are not lost.
Press
Go to clear the
message.
If you want to perform the
defragment operation,
delete fonts, macros, and
other data in RAM and try
again or install more
memory.
Message Status Action