Filter
Top Products
3-20 Service Manual
5016-001
Setting Configuration ID
The configuration ID is used to communicate information about
certain areas of the printer that cannot be determined using
hardware sensors. The Configuration ID is originally set at the
factory when the printer is manufactured, however it requires
resetting whenever you replace the controller board and can be set
on the operator panel. However the Configuration ID is the only
diagnostic function displayed until a valid ID is entered.
CONFIG IDs to be used for the 5016-001 printer:
• 000000 ID set when the operator panel is to support
850 + Katakana and not allow the power saver to be reset.
• 100001 ID set when the operator panel is to support
850 + Katakana and allow the power saver to be reset.
• 000088 ID set when the operator panel is to support
850 + NLS and not allow the power saver to be reset.
• 100089 ID set when the operator panel is to support
850 + NLS and allow the power saver to be reset.
To set the Configuration ID:
1. Enter Diagnostics Mode.
2. Select Configuration ID from the Printer Setup menu. The
current ID displays on the screen. The display should show one
of the IDs from the above list. The leftmost digit blinks indicating
that it is the first digit to be changed.
3. To change the value, press either Menu> or <Menu until the
desired value is reached. Press Select to move to the next digit,
or press Select again to skip a digit. Change each digit as
required. When the last digit is changed, press Select to
validate the Configuration ID. If the ID is invalid then "INVALID
ID" message displays on Line 2 before the ID re-displays. You
have to reenter the Configuration ID until a valid ID is verified. If
the ID is valid then the ID is saved in NVRAM and the printer
automatically PORs to activate the new setting.
Note: When the printer PORs it does so in the normal mode.