Filter
Top Products
Repair Information 4-11
5016-001
Take care when removing the cables on the right side of the printer.
Always ensure to route the cables through the appropriate cable
clips as shown.
1. Remove the right side cover, refer to the “Right Side Cover
Removal” on page 4-4.
2. Disconnect the three (3) cables [A] from the top of the LVPS
assembly and un-route the cable from the assembly.
Note: Take notice of the white wire/black wire notation on the LVPS
board.
3. Disconnect the three (3) cables [B] from the bottom of the LVPS
assembly.
4. Remove the five (5) screws [C] from the LVPS assembly.
5. Lift the LVPS assembly upward and out of the printer.