Filter
Top Products
Diagnostic Information 2-107
5016-001
Hard Disk Option Service Check
Verify the hard disk and the hard disk board are correctly installed.
When a problem is suspected, either with the hard disk system
board or the hard disk, run the “Quick Disk Test” on page 3-16.
Note: The Quick Disk Test is a non-destructive test and indicates
pass or fail. If the test fails, replace the hard disk. If a problem still
exists, replace the hard disk board.
The “Disk Test/Clean” on page 3-17 is used to restore the disk, if
the disk is unusable, or contains bad data. This test is divided into a
cleaning and a verifying or testing section.
Note: This test leaves the hard disk unformatted and can be a very
lengthy test, depending on disk size. The servicer, or user, must
reformat the disk using the Format Disk Menu operation. The test
destroys all data and should not be performed on a known good
disk.