Filter
Top Products
Chapter 5 Programming
©
National Instruments Corporation 5-31 AT-MIO-16X User Manual
Figure 5-9. Pulsed Cyclic Waveform Programming
In this mode, Counter 1 counts the programmed number of cycles
before terminating the sequence. Counter 2 then begins counting the
time between cycles, the cycle interval, then restarts the sequence. This
END
START
Clear the analog output
circuitry including the
DAC FIFO
Program the update
interval counter
Set the A4RCV bit in
Command Register 2
Set the waveform
generation mode
Service update requests
Clear the A4RCV
bit in Command
Register 2
Yes
No
Enable updating
Program the cycle counter
Select the update counter
via RTSI programming
Program the cycle interval
counter
Internal
update ?