National Instruments AT-MIO-16X Switch User Manual


 
Index
AT-MIO-16X User Manual I-16
©
National Instruments Corporation
R
reference calibration, 6-8 to 6-9
reference selection, analog output, 2-11
referenced single-ended input (RSE). See RSE
(referenced single-ended input).
register-level programming, 1-6
registers
ADC Calibration Register, 4-52
ADC Event Strobe Register Group,
4-46 to 4-52
ADC FIFO Register
clearing analog input circuitry, 5-14
description, 4-32 to 4-34
interrupt programming, 5-43
reading single conversion result, 5-7
servicing data acquisition
operation, 5-22
Am9513A Command Register, 4-66
Am9513A Counter/Timer Register
Group, 4-64 to 4-67
programming
general considerations, 5-37
resource allocation
considerations, 5-1 to 5-2
sample counters, 5-17 to 5-20
sample-interval counter,
5-16 to 5-17
scan interval counter,
5-20 to 5-21
update-interval counter,
5-32 to 5-33
waveform cycle counter, 5-34
waveform cycle interval counter,
5-34 to 5-36
resetting after data acquisition
operation, 5-23 to 5-24
Am9513A Data Register, 4-65
Am9513A Status Register, 4-67
Analog Input Register Group,
4-31 to 4-40
Analog Output Register Group,
4-41 to 4-43
analog output voltage versus digital
code
bipolar mode (table),
4-42 to 4-43
unipolar mode (table), 4-42
formula for voltage output versus
digital code, 4-42
Calibration DAC 0 Load Register, 4-62
Calibration DAC 1 Load Register, 4-63
Command Register 1, 4-5 to 4-8
Command Register 2
description, 4-9 to 4-12
interrupt programming, 5-43
programming digital I/O
circuitry, 5-36
Command Register 3, 4-13 to 4-19
Command Register 4, 4-20 to 4-24
CONFIGMEM Register
description, 4-35 to 4-40
programming multiple-analog input
channel configurations, 5-16
programming single-analog input
channel configurations, 5-15
CONFIGMEMCLR Register
description, 4-47
programming multiple-analog input
channel configurations, 5-16
programming single-analog input
channel configurations, 5-15
CONFIGMEMLD Register
description, 4-48
programming multiple-analog input
channel configurations, 5-16
programming single-analog input
channel configurations, 5-15
Configuration and Status Register Group,
4-4 to 4-30
DAC Clear Register
clearing analog output circuitry, 5-32