Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION
4 - 32
(5) Remove 3 screws and take off the front sad-
dle stapler clinch unit.
(6) Remove 3 screws and take off the rear sad-
dle stapler clinch unit.
Fig. 4-88
(7) Disconnect each connector of the front and
saddle stapler drive units from the SDL board
side.
(8) Remove 2 screws and take off the front sad-
dle stapler drive unit.
(9) Remove 2 screws and take off the rear sad-
dle stapler drive unit.
Fig. 4-89
(10) Remove the fold plate.
Note:
When replacing the fold plate (ASYS-PLT-
FOLD-RLR-SDL), be careful not to damage
the mylar.
Fig. 4-90
Front saddle stapler
clinch unit
Rear saddle stapler
clinch unit
Connector
Rear saddle stapler
drive unit
Front saddle stapler
drive unit
Mylar
Fold plate