Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION
4 - 90
[I] Assisting roller solenoid (SOL6) (MJ-1104)
(1) Take off the stacker unit.
P.4-37 "[H] Stacker unit"
(2) Take off the paper holding unit.
P.4-29 "[C] Paper holding unit"
(3) Remove 4 screws of the stacker guide.
Note:
Be careful not to damage the harness fixed
on the back side of the stacker guide with a
clamp.
Fig. 4-252
(4) Release the harness out of 2 clamps, and
then disconnect the relay connector.
Fig. 4-253
(5) Take off the spring.
(6) Remove 2 screws, and then take off the
assisting roller solenoid.
Fig. 4-254
Stacker guide
Clamp
Relay
connector
Spring
Assisting roller
solenoid