Filter
Top Products
4
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4 - 113
[E] Stacker paper detection sensor (S30)
(1) Take off the switchback unit.
P.4-28 "[B] Switchback unit"
(2) Take off the paper holding unit.
P.4-29 "[C] Paper holding unit"
(3) Remove 2 screws of the stacker guide.
Note:
Be careful not to damage the harness fixed
on the back side of the stacker guide with a
clamp.
Fig. 4-320
(4) Release the harness out of 3 clamps.
(5) Remove 2 screws, and take off the sensor
bracket.
Fig. 4-321
(6) Release the latch, and then take off the
stacker paper detection sensor.
Fig. 4-322
Stacker guide
Clamp
Sensor bracket
Stacker paper
detection sensor