Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION
4 - 28
[B] Switchback unit
Notes:
When the saddle unit was installed, take off
the saddle cover to check if the joint section
of the pivot on the Finisher side and the plate
on the saddle unit side is smooth.
1. Take off the saddle tray.
P.4-2 "[C] Saddle tray"
2. Open and close the saddle unit to check if
the joint section of the pivot on the Fin-
isher side and the plate on the saddle unit
side is smooth, and also if the plate on the
Finisher side contacts with the plate on
the saddle unit side at 4 positions.
3. If not, loosen 2 screws of the Finisher
side bracket and 1 screw on the saddle
unit side to determine the proper posi-
tions while the saddle unit is left closed.
Fig. 4-76
Fig. 4-77
(1) Take off the saddle unit.
P.4-26 "[A] Saddle unit"
(2) Remove 4 screws, and then take off the
upper safety cover.
Fig. 4-78
Proper position
Adjustment required
4 sections of the
plate are contacted
Any of 4 sections
is not contacted
Saddle unit
side plate
Saddle unit
side plate
Finisher
side plate
Finisher
side plate
Saddle unit
side plate
Finisher
side plate
Pivot
Upper safty cover