Filter
Top Products
4
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4 - 97
(4) Take off the belt from the stack transport
motor.
Fig. 4-273
(5) Remove 3 screws, and then disconnect each
connector of the finishing tray paper detec-
tion sensor and the stack exit belt home posi-
tion sensor and the relay connector of the
paper exit guide clutch. Then take off the
stack exit belt unit.
Notes:
• Be sure not to lose the belt.
• When installing the stack transport belt
unit, attach the rotation protection of the
paper exit guide clutch.
Fig. 4-274
(6) Remove 1 screw, and then take off the sen-
sor bracket.
Note:
When taking off the sensor bracket, the actu-
ator and the spring are also taken off. Be
sure not to lose the actuator and the spring.
Fig. 4-275
Stack transport motor
Belt
rotation
protection
Stack exit belt unit
Paper exit
guide clutch
Sensor bracket