Filter
Top Products
4
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4 - 29
[C] Paper holding unit
(3) Release the harness out of 9 clamps, and
then disconnect each connector of CN8 and
CN20 on the SDL board.
Fig. 4-79
(4) Remove 4 screws, and then take off the sup-
port bracket.
(5) Remove 4 screws, and then take off the front
bracket.
(6) Remove 4 screws, and then take off the rear
bracket.
(7) Remove 4 screws, and then take off the
switchback unit.
Fig. 4-80
(1) Take off the front lower cover.
P.4-4 "[E] Front cover / Front upper cover
/ Front lower cover"
(2) Remove 2 screws, and then take off the
paper holding unit.
Notes:
• Do not lose the clutch shaft bushing.
• When installing, engage the clutch shaft
bushing with the frame of the paper hold-
ing unit securely.
Fig. 4-81
SDL board
Clamp
Switchback unit
Rear bracket
Support
bracket
Front bracket
Paper holding unit
Bushing