Filter
Top Products
3
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved MJ-1103/1104
DESCRIPTION OF OPERATIONS
3 - 3
3.1.2 Junction Box
Paper transported from the connected device is then detected by the feeding sensor (S22) and caught
with the feeding roller. Then it is transported to the Finisher section or the saddle stitch section after the
transport path switching solenoid (SOL5) switches its transport path with a flapper.
When it is transported to the Finisher section, the flapper does not move but the entrance roller trans-
ports it to the Finisher section.
When it is transported to the saddle stitch section, the transport path switching solenoid (SOL5) is
turned ON to switch the transport path with the flapper. The paper is then transported to the saddle
stitch section with the junction roller. The junction box paper detection sensor (S26) detects the passing
of the paper.
The feeding roller and the junction roller are driven by the entrance motor (M1) of the Finisher section.
Fig. 3-4
Feeding sensor
Junction box paper detection sensor
Feeding roller
Junction roller
Transport path switching solenoid
Flapper
Entrance roller
Entrance motor