Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION
4 - 6
[F] Handle cover / Cover lock bracket
[G] Rear cover
[H] Access cover
(1) Open the front cover (MJ-1103) or the front
upper cover (MJ-1104).
(2) Remove 2 screws, and then take off the han-
dle cover.
(3) Remove 1 screw, and then take off the cover
lock bracket.
Fig. 4-15
(1) Remove the finisher cable out of the groove
of the rear cover.
(2) Remove 5 screws, and then take off the rear
cover by sliding it upward.
Fig. 4-16
(1) Remove 2 screws, and then take off the
access cover by sliding it upward.
Note:
When installing, hang 5 hooks of the board
access cover on the holes of rear cover.
Fig. 4-17
Handle cover
Cover lock
bracket
Finisher cable
Rear cover
Board access cover