Filter
Top Products
6
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved MJ-1103/1104
TROUBLESHOOTING
6 - 25
6.3.2 Saddle Stitch Finisher stapler related error (MJ-1104)
[EF11] Front saddle staple error
Is there any paper remaining on the paper transport path in the Finisher or the equipment, or on
the finishing tray?
YES Remove the paper.
NO
Is the jam released by taking off the front staple cartridge from the Finisher and removing the
staple sheet slid from the staple case?
YES End.
NO
Is the harness between the front saddle stapler drive unit and the CN3 of the saddle control PC
board (SDL) disconnected or open circuited?
l
YES • Reconnect the connector securely.
• Replace the harness if open circuited.
NO
1. Reconnect the connector securely if there is any disconnection.
2. Replace the saddle control PC board (SDL).
[EF12] Rear saddle staple error
Is there any paper remaining on the paper transport path in the Finisher or the equipment, or on
the finishing tray?
YES Remove the paper.
NO
Is the jam released by taking off the rear staple cartridge from the Finisher and removing the sta-
ple sheet slid from the staple case?
YES End.
NO
Is the harness between the rear saddle stapler drive unit and the CN3 of the saddle control PC
board (SDL) disconnected or open circuited?
l
YES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
1. Replace the rear saddle stapler drive unit.
2. Replace the saddle control PC board (SDL).
[CBA0] Front saddle stapler home position error
Is the harness between the front saddle stapler clinch unit and the CN6 of the saddle control PC
board (SDL) disconnected or open circuited?
l
YES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
1. Replace the front saddle stapler clinch unit.
2. Replace the saddle control PC board (SDL).