Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION
4 - 98
[J] Stapler unit home position sensor (S10)
[K] Stapler interference sensor (S11) / Actuator
(7) Release the latch, and then take off the stack
exit belt home position sensor.
Fig. 4-276
(1) Open the front cover (MJ-1103) or the front
upper cover (MJ-1104).
(2) Move the stapler to the position where the
stapler unit home position sensor is seen.
(3) Release the latch, and then disconnect the
connector to take off the stapler unit home
position sensor.
Fig. 4-277
(1) Take off the stapler.
P.4-22 "[E] Stapler"
(2) Release the latch, and then disconnect the
connector to take off the stapler interference
sensor.
Fig. 4-278
Stack exit belt
home position sensor
Stapler unit home position sensor
Stapler interference sensor