Filter
Top Products
4
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4 - 35
[G] EFS unit
(1) Take off the folding drive unit.
P.4-33 "[F] Folding drive unit"
(2) Release the harness out of 9 clamps, and
then disconnect the connector of CN18 on
the SDL board.
Fig. 4-97
(3) Disconnect each connector of CN4, CN15
and CN19 on the SDL board. Break binding
wire at one position and release the harness
from 7 clamps.
Fig. 4-98
(4) Release the harness out of 3 clamps.
Disconnect the connector of the stacker
home position sensor. Disconnect the relay
connector of the stacker motor. Disconnect
the relay connector of the saddle tray paper
detection sensor.
Fig. 4-99
SDL board
Clanp
SDL board
Clamp
Binding
wire
connctor
relay connector
Clamp
Clamp