Filter
Top Products
3
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved MJ-1103/1104
DESCRIPTION OF OPERATIONS
3 - 9
3.1.4 Job offset stack mode / Staple stack mode
The job offset stack mode exits stacks of paper by slightly shifting them to the front and rear alternately,
and the staple stack mode staples and exits stacks of paper. In both modes, paper transported from the
feeding section is stacked on the buffer tray in the unit of 1 to 3 sheets.
The stacked paper is then moved to the finishing tray by the active drop mechanism. On the finishing
tray the alignment of the stacks of paper and the job offsetting are performed.
In case a stack mode shifts to the staple stack mode after this, the stack of paper is stapled and exited
to the movable tray.
[A] Paper transport section
At this stage, the buffer roller lift solenoid (SOL2) is turned ON to raise the buffer rollers and the buffer
tray is moved by the buffer tray guide motor (M2) to the position where it matches with the paper width.
The home position of the buffer tray is detected by the buffer tray home position sensor (S5).
Fig. 3-10
Buffer tray guide motor
Buffer tray
Buffer roller lift solenoid
Buffer tray
home position sensor
Buffer roller