Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION
4 - 114
[F] Exit sensor (S31)
[G] Saddle tray paper detection sensor (S32)
(1) Open the front upper cover and then pull out
the saddle unit.
(2) Remove 1 screw, and then disconnect the
connector and take off the sensor bracket.
Fig. 4-323
(3) Release the latch, and then take off the exit
sensor.
Fig. 4-324
(1) Open the front upper cover and then pull out
the saddle unit.
(2) Remove 1 screw, and then disconnect the
connector and take off the sensor bracket.
Note:
When the sensor was installed, be sure to
adjust the position of the sensor bracket.
P.4-26 "[A] Saddle unit"
Fig. 4-325
Sensor bracket
Exit sensor
Sensor bracket