Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION
4 - 38
4.4 Rollers (Finisher section)
[A] Feeding roller
(1) Take off the right upper cover.
P.4-7 "[J] Right upper cover"
(2) Take off the relay guide, feeding discharge
brush and right cover.
P.4-7 "[K] Relay guide / Feeding dis-
charge brush / Right cover"
(3) Remove 4 screws of the FIN board bracket.
Fig. 4-104
(4) Release the harness out of 1 clamp, and
then disconnect each connector of CN6 and
CN8 on the IF board.
(5) Remove 2 screws of the IF board bracket.
Note:
When installing, screw the ground terminal
together with the bracket.
Fig. 4-105
(6) Remove 2 screws, and then take off the front
bracket.
(7) Remove 2 screws, and then take off the rear
bracket.
(8) Remove 2 screws, and then take off the junc-
tion box upper transport guide.
Fig. 4-106
FIN board
I/F board
Clamp
Rear bracket
Front bracket Junction box upper
transport guide