Filter
Top Products
4
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4 - 85
(8) Remove 2 screws, and then disconnect the
relay connector and remove the arm to take
off the bracket.
Note:
When installing the gate solenoid, adjust the
edge of the bracket to come at the mark on
the scale one step left from the center as
shown in the figure and fix it with 2 screws.
Fig. 4-240
Fig. 4-241
Relay connector
Bracket
BracketScale