Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENTS
5 - 10
5.3.2 Stapling position adjustment
(1) Turn OFF the power of the equipment.
(2) Remove 2 screw and take off the board access cover.
(3) Set the SW1 on the Finisher control board as shown in the figures below.
Turn ON pin 1 and 4.
Fig. 5-14
(4) Turn ON the power of the equipment while [0] button and [8] button are pressed simultaneously.
(5) Press [Button 1] on the touch panel 10 times and then press [Button 2] once. Then press [Button
1] once again, and [Button 2] once again. (Adjustment of LD and A3 paper starts.)
Fig. 5-15
ON
1 2 3 4
Board access cover
LED3 LED2 LED1
Button2Button1